Monday, May 24, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 471

2010 Cadillac Truck SRX FWD V6-3.0L Page 471



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming



B1480



DTC B1480



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC B1480 02



- Battery Rundown Protection Circuit Short to Ground



Diagnostic Fault Information



Circuit/System Description



The battery saver mode reduces the parasitic load of some modules during overseas shipment or during vehicle storage conditions. This improves



the drain time on the battery of up to 70 days without the battery going dead. When the vehicle is in transport/storage, some features may have



reduce functionality as a result being in the battery saver mode, such as disabling the Remote Function Actuator or content theft features.



The battery saver mode incorporates a latching relay that when enabled disconnects some modules from their ignition off power or memory power



sources. Battery saver mode is initiated by starting the vehicle and then turning the ignition key into the crank position for greater than 15 seconds.



The mode is disengaged by repeating the previous process causing the relay to latch in the other direction. This feature can be used as many times



as necessary if the vehicle is to be stored for an extended period of time.



Conditions for Running the DTC



* The system voltage is between 9-16 V.



* The DTC can only run when the output is activated.



Conditions for Setting the DTC



The BCM detects a short to ground in the battery saver relay set circuit.



Action Taken When the DTC Sets



The module output driver will be shut down and not supply voltage to the battery saver relay set circuit.



Conditions for Clearing the DTC



* The current DTC will clear when the module request for the output is removed or the malfunction is no longer present.



* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.



Reference Information



Schematic Reference



* Body Control System Schematics (See: Body and Frame/Body Control Systems/Diagrams/Electrical Diagrams)



* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System



Diagram/Power Distribution Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Power Mode Description and Operation (See: Power and Ground Distribution/Description and Operation/Power Mode)



Electrical Information Reference

No comments:

Post a Comment