Friday, May 7, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 696

2010 Cadillac Truck SRX FWD V6-3.0L Page 696



The BCM detects a short to ground in the headlamp flash to pass signal circuit for greater than 15 seconds.



Action Taken When the DTC Sets



The high beam headlamps will malfunction.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System



Diagram/Headlights/Daytime Running Lights (DRL) Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool Headlamps Flash Switch parameter while pulling and releasing the turn signal/multifunction switch. The value



should change between Inactive and Active when changing between the selected states.



Circuit/System Testing



1. Ignition OFF, disconnect at the S78 turn signal/multifunction switch.



2. Ignition ON, verify that the scan tool Headlamps Flash Switch parameter is Inactive.



瀚慖f not the specified value, test the signal circuit terminal 4 for a short to ground. If the circuit tests normal, replace the K9 BCM.



3. Connect a 3 A fused jumper wire between the signal circuit terminal 4 and ground, verify that the scan tool Headlamps Flash Switch



parameter is Active.



瀚慖f not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9



BCM.



4. If all circuits test normal, test or replace the S78 turn signal/multifunction switch.



Component Testing



Turn Signal/Multifunction Switch Test



1. Ignition OFF, disconnect the harness connector at the S78 turn signal/multifunction switch.



2. Test for Infinite resistance between the terminals listed below with the switch in the open position.



* Signal terminal 2 and ground terminal 3



* Signal terminal 4 and ground terminal 3



瀚慖f not the specified value, replace the S78 turn signal/multifunction switch.

No comments:

Post a Comment