Sunday, May 23, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1573

2010 Cadillac Truck SRX AWD V6-3.0L Page 1573



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Cruise Control Description and Operation (See: Cruise Control/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the X1 (LF1) or X2 (LAU) harness connector at the K20 ECM.



2. Connect a test lamp between the appropriate signal circuit terminal listed below and ground.



* Terminal 57 (LF1)



* Terminal 52 (LAU)



3. Ignition ON, verify the test lamp turns ON and OFF when pressing and releasing the brake pedal.



瀚慖f the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.



瀚慖f the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



4. If all circuits test normal, replace the K20 ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM or ECM, replacement, setup, and programming



P0575



DTC P0575



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0575



- Cruise Control Switch Signal Circuit



Circuit/System Description



When a cruise control function switch is activated, the body control module (BCM) detects a predetermined voltage. The BCM sends a serial data



message to the engine control module (ECM) indicating the function that has been requested.



Conditions for Running the DTC

No comments:

Post a Comment