2010 Cadillac Truck SRX FWD V6-3.0L Page 514

2010 Cadillac Truck SRX FWD V6-3.0L Page 514

Conditions for Clearing the DTC

* The current DTC will clear and set the code to history 3 seconds after the reference voltage returns to normal operating range and the ignition

is cycled OFF then back to ACC or RUN.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Heated/Vented Seat Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Heated/Vented

Seat)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate E14B or E14D seat cushion heating element.

2. Test for less than 10 Ohms between the low reference circuit terminal D and ground.

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit test normal, replace the K40 seat

memory control module.

3. Ignition ON, press a power seat switch in order to wake up the module. Test for 4.8 - 5.2 V between the signal circuit terminal C and ground.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the K40 seat memory control module.

瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K40 seat memory

control module.

4. If all circuits test normal, test or replace the E14 seat cushion heating element.

Component Testing

E14B or E14D Seat Cushion Heating Element

1. Ignition OFF, disconnect the harness connector at the appropriate E14B or E14D seat cushion heating element.

2. Test for 500 Ohms - 300 kOhms between the signal circuit terminal C and the low reference circuit terminal D.

瀚慖f not within the specified range, replace the E14 seat cushion heating element.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Driver or Passenger Seat Cushion Heater Replacement (See: Body and Frame/Seats/Seat Temperature Element/Service and Repair/Driver or

Passenger Seat Cushion Heater Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for seat memory control module replacement, setup,