Saturday, April 24, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 60

2010 Cadillac Truck SRX FWD V6-3.0L Page 60



2. Disconnect the scan tool.



3. Wait for 120 seconds and then test for greater than 25 ohm between the seat belt anchor pretensioner control circuits terminal 1 and terminal



2.



瀚慖f less than the specified range, test for a short between the control circuits, check each connector and CPA to ensure that the shorting



bars are lifted. If the circuits and shorting bars tests normal, replace the K36 SDM.



4. Ignition ON, test for less than 11 V between each of the seat belt anchor pretensioner control circuit terminals 1 and 2 and ground.



瀚慖f greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K36 SDM.



5. Ignition OFF, test for greater than 25 ohm between each of the seat belt anchor pretensioner control circuit terminals 1 and 2 and ground.



瀚慖f less than the specified range, test the control circuit for a short to ground. If the circuit tests normal, replace the K36 SDM.



6. Install a 3 A fused jumper wire between the seat belt anchor pretensioner control circuits terminal 1 and terminal 2.



7. Verify the scan tool Deployment Loop Resistance parameter is less than 2 ohm.



瀚慖f greater than the specified range, test the control circuit terminals 1 and 2 for an open/high resistance. If the circuits test normal, replace



the K36 SDM.



8. If all circuits test normal, replace the F113 seat belt anchor pretensioner.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Driver or Passenger Seat Belt Tensioner Replacement (See: Restraints and Safety Systems/Seat Belt Systems/Seat Belt Tensioner/Service



and Repair/Removal and Replacement/Driver or Passenger Seat Belt Tensioner Replacement)



* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming



B001B



DTC B001A or B001B



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provide an overview of each diagnostic category.



DTC Descriptors



DTC B001A 01



- Driver Seat Belt Anchor Pretensioner Deployment Loop Short to Battery



DTC B001A 02



- Driver Seat Belt Anchor Pretensioner Deployment Loop Short to Ground



DTC B001A 04



- Driver Seat Belt Anchor Pretensioner Deployment Loop Open



DTC B001A 0D



- Driver Seat Belt Anchor Pretensioner Deployment Loop High Resistance



DTC B001A 0E



- Driver Seat Belt Anchor Pretensioner Deployment Loop Low Resistance



DTC B001B 01



- Passenger Seat Belt Anchor Pretensioner Deployment Loop Short to Battery



DTC B001B 02



- Passenger Seat Belt Anchor Pretensioner Deployment Loop Short to Ground

No comments:

Post a Comment