Monday, April 19, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1552

2010 Cadillac Truck SRX AWD V6-3.0L Page 1552



4. Verify the scan tool A/C High Side Pressure Sensor parameter is less than 0.3V.



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control



Module.



5. Install a 3A fused jumper wire between the following signal circuit terminal 3 and the 5V reference circuit terminal 2. Verify the scan tool



A/C high side pressure sensor parameter is greater than 4.8V.



瀚慖f less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the



K20 Engine Control Module.



6. If all circuits test normal, replace the B1 A/C Refrigerant Pressure Sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* HVAC Component Replacement Reference (See: Heating and Air Conditioning/Service and Repair/Removal and Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning)



P0533



DTC P0532 or P0533



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0532 00



- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Low Voltage



DTC P0533 00



- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit High Voltage



Circuit/System Description



The engine control module (ECM) monitors the high side refrigerant pressure through the A/C refrigerant pressure sensor. The ECM supplies a 5 V



reference and a low reference to the sensor. Changes in the A/C refrigerant pressure cause the sensor signal to the ECM to vary. When the pressure



is high, the signal voltage is high. When the pressure is low, the signal voltage is low. When pressure is high, the ECM commands the cooling fans



on. When pressure is too high or too low, the ECM will not allow the activation of the A/C compressor.



Conditions for Running the DTC



Engine is running.



Conditions for Setting the DTC



P0532 00



The ECM detects a short to ground or open at the A/C pressure sensor signal circuit.



P0533 00



The ECM detects a short to voltage at the A/C pressure sensor signal circuit.



Action Taken When the DTC Sets



* The A/C compressor is disabled.



* The ECM will illuminate the malfunction indicator lamp (MIL).



Conditions for Clearing the DTC

No comments:

Post a Comment