2010 Cadillac Truck SRX AWD V6-3.0L Page 1864

2010 Cadillac Truck SRX AWD V6-3.0L Page 1864

瀚慖f any TFP Switch parameter does not change states, replace the control solenoid valve assembly.

Repair Instructions

Note:

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission

and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic

Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup, or

programming

P1101

DTC P0068 or P1101

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P0068

- Throttle Body Airflow Performance

DTC P1101

- Intake Air Flow System Performance

Circuit/System Description

The engine control module (ECM) compares actual airflow based on throttle position (TP) to a calculated airflow based on manifold absolute

pressure (MAP) sensor, and mass air flow (MAF).

Conditions for Running the DTC

DTC P0068

* The engine speed is greater than 800 RPM.

* The ignition voltage is greater than 6.0 V.

* The throttle actuator control system is not in reduced power mode.

* The DTC runs continuously when the above conditions are met.

DTC P1101

* DTCs P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0335, P0336 are not set

* The engine speed is between 400-7,000 RPM

* The engine coolant temperature (ECT) is between 69-127掳C (156-260掳F).

* The intake air temperature (IAT) is between -20 to +125掳C (-4 to +257掳F).

* The DTC runs continuously when the above conditions are met.

Conditions for Setting the DTC

The ECM detects that the actual airflow rate is greater than the calculated airflow.

Action Taken When the DTC Sets

* DTC P0068 is a type A DTC.

* DTC P1101 is a type B DTC.

Conditions for Clearing the DTC