2010 Cadillac CTS Sedan AWD V6-3.6L Page 691

2010 Cadillac CTS Sedan AWD V6-3.6L Page 691

when driving in a straight line at a constant speed greater than 20 km/h (13 mph), and will vary as the vehicle changes direction.

Circuit/System Testing

1. Verify that DTC U1826 or U1827 and not set.

瀚慖f DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble

Code (DTC) List - Vehicle).

2. Verify the yaw/lateral accelerometer sensor is mounted properly.

瀚慖f not mounted properly, refer to Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement (See: Brakes and Traction

Control/Antilock Brakes / Traction Control Systems/Yaw Rate Sensor/Service and Repair).

3. Ignition OFF, disconnect the harness connector at the yaw/lateral accelerometer sensor.

4. Ignition OFF, wait 1 minute, test for less than 10 ohm between the low reference circuit terminal 6 and ground.

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuits test normal, replace the EBCM.

5. Ignition ON, test for B+ between the ignition voltage circuit terminal 1 and ground.

瀚慖f not within the specified range, test the ignition voltage circuit for a short to ground or open/high resistance. If the circuits test normal,

replace the EBCM.

6. If all circuits test normal, replace the yaw/lateral accelerometer sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction

Control Systems/Yaw Rate Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup and programming

C0201

DTC C0201

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC C0201 04

- Antilock Brake System (ABS) Enable Relay Contact Open Circuit

Circuit/System Description

The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.

Conditions for Running the DTC

* Ignition ON.

* Ignition voltage is greater than 10 volts.

* The solenoid relay is commanded ON.

Conditions for Setting the DTC

* The EBCM detects an open in the battery positive voltage circuit to the solenoid valve relay.

* The EBCM detects a stuck open solenoid valve relay or an open circuit between the solenoid valve relay and solenoids.

Actions Taken when the DTC Sets