Friday, February 26, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-08-42-001 Date: 100514

2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-08-42-001 Date: 100514



Lighting - Low Beam Headlamp(s) Inoperative



TECHNICAL



Bulletin No.: 10-08-42-001



Date: May 14, 2010



Subject: Low Beam Headlamp Bulb Diagnosis/Replacement (Inspect Bulb and Connector)



Models:



2008-2010 Buick Enclave



2008-2010 Cadillac CTS, CTS-V



2010 Cadillac CTS Sport Wagon, SRX



2007-2010 Cadillac Escalade, Escalade ESV, Escalade EXT



2007-2010 Chevrolet Avalanche, Silverado, Suburban, Tahoe



2008-2010 Chevrolet Malibu



2009-2010 Chevrolet Traverse



2010 Cadillac Truck SRX AWD V6-3.0L Page 234



2007-2010 GMC Acadia, Sierra, Yukon, Yukon XL, Yukon Denali, Yukon Denali XL



2006-2010 Pontiac G6



2007-2010 Saturn AURA



Attention:



This bulletin DOES NOT apply to vehicles equipped with High Intensity Discharge (HID) lamps.



Condition



Some customers may comment that the low beam headlamp is inoperative.



Correction



DO NOT replace the entire headlamp assembly for this condition.



Replace the bulb and inspect the connector following the procedure below.



1. Remove the lamp assembly, then remove the bulb. Refer to Headlamp Assembly Replacement in SI.



2. Inspect the connector.



- If the connector is NOT discolored or damaged, replace the bulb only. For bulb part numbers, see Headlamp Bulb (Low Beam) in Group



02.727 of the appropriate Parts Catalog.



- If the connector is discolored at the bulb interface, replace the connector (service pigtail listed below) and bulb.



Important



Use only Duraseal splice sleeves (salmon, P/N 12089189). Other splice sleeves may not protect the splice from moisture or



provide a good electrical connection. Refer to Splicing Copper Wire Using Splice Sleeves in SI for splicing procedures.



1. Cut the wires of the connector approximately 45 mm (1-3/4 in) from the connector and splice in the service pigtail connector. Ensure



that the splices are not above the connector when re-installing.



2. Replace the bulb.



3. Verify that the headlamp is fully functional.



Parts Information



Warranty Information



For vehicles repaired under warranty, use:



If only bulbs are replaced, use labor operation N0440 or N0441.



2010 Cadillac Truck SRX AWD V6-3.0L Page 235

No comments:

Post a Comment