2010 Cadillac Truck SRX AWD V6-3.0L Page 1890

2010 Cadillac Truck SRX AWD V6-3.0L Page 1890

* Vehicle starting will be disabled.

Conditions for Clearing the DTC

* A current DTC P1631 will be cleared when correct immobilizer data is received.

* A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.

Reference Information

Schematic Reference

Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

Operation/Immobilizer)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Verification

Note: Because of normal system communications between the BCM and ECM, any immobilizer B-codes must be diagnosed prior to the diagnosis

of P-codes.

Perform the BCM immobilizer learn using the Body Control Module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to

Immobilizer System Component Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and

Inspection/Programming and Relearning). The BCM should successfully complete the learn and the vehicle should start.

If vehicle starting is not restored, perform the ECM immobilizer learn using the Engine Control Module IMMO Learn in SPS. Refer to Immobilizer

System Component Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming

and Relearning).

P1649

DTC P1649

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC P1649

- Immobilizer Security Code Not Programmed

Circuit/System Description

When learning the security code, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode. Once

the security code and challenge/response are learned, learn mode will be exited when the engine is successfully started.