Test 1: Check component Y22/6 (variable intake manifold switchover valve).
1. Check component Y22/6 (variable intake manifold switchover valve).
Test 1.1: Test actuation of component Y22/6 (variable intake manifold switchover valve).
Test 1.2: Test current consumption of component Y22/6 (variable intake manifold switchover valve).
1.1. Test actuation of component Y22/6 (variable intake manifold switchover valve).
Test prerequisite
- The vacuum system is leaktight.
Test sequence
- Run the engine for a short time and switch off again.
- Switch on ignition.
- Actuate component Y22/6 (variable intake manifold switchover valve).(Actuate with key F2.)
Specified value
- Testing The rod of the vacuum unit can be seen to operate.(See arrow)
Warning!Communication with ECU required.
1.2. Test current consumption of component Y22/6 (variable intake manifold switchover valve).
Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!
- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
No comments:
Post a Comment