Thursday, November 19, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 298

2010 Cadillac Truck SRX AWD V6-3.0L Page 298



Conditions for Running the DTC



The headlamps are turned ON.



Conditions for Setting the DTC



B257C 00



The headlamp control module detects a fault in the left low beam control circuit or an open/high resistance is the left low beam ground circuit.



B257D 00



The headlamp control module detects a fault in the right low beam control circuit or an open/high resistance is the right low beam ground circuit.



Action Taken When the DTC Sets



The appropriate headlamp is inoperative.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System



Diagram/Headlights/Daytime Running Lights (DRL) Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the function of the low beam headlamps while commanding the Low Beam Lamps ON and OFF with a scan tool. The E4G



headlamp-left low beam and the E4H headlamp-right low beam should turn ON and OFF while changing between the commanded states.



If the E4G headlamp-left low beam is always OFF, refer to Left Low Beam Inoperative



If the E4H headlamp-right low beam is always OFF, refer to Right Low Beam Inoperative



If both low beam headlamps are always ON or always OFF, refer to Headlamps Malfunction



Circuit/System Testing



Left Low Beam Inoperative



1. Ignition OFF, disconnect the X118 inline harness connector at the E4G headlamp-left low beam.



2. Connect a test lamp between the control circuit terminal G and ground.



3. Ignition ON, command the Low Beam Lamps ON with a scan tool, the test should illuminate while commanding the headlamp ON.



瀚慖f the test lamp does not illuminate and the circuit fuse is good, test the control circuit for an open/high resistance.

No comments:

Post a Comment