2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1921
DTC P0205
- Injector 5 Control Circuit
DTC P0206
- Injector 6 Control Circuit
DTC P0207
- Injector 7 Control Circuit
DTC P0208
- Injector 8 Control Circuit
Diagnostic Fault Information
Circuit/System Description
The control module enables the appropriate fuel injector pulse for each cylinder. Ignition voltage is supplied to the fuel injectors. The control
module controls each fuel injector by grounding the control circuit via a solid state device called a driver. The control module monitors the status of
each driver.
Conditions for Running the DTC
* The engine is running.
* The ignition voltage is greater than 11 V.
* DTC P0201-P0208 runs continuously when the above conditions are met.
Conditions for Setting the DTC
The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2 s.
Action Taken When the DTC Sets
DTCs P0201, P0202, P0203, P0204, P0205, P0206, P0207, and P0208 are Type B DTCs.
Conditions for Clearing the MIL/DTC
DTCs P0201, P0202, P0203, P0204, P0205, P0206, P0207, and P0208 are Type B DTCs.
Diagnostic Aids
Performing the Fuel Injector Diagnosis may help isolate an intermittent condition. Refer to Fuel Injector Diagnosis (CH47976) (See: Powertrain
Management/Fuel Delivery and Air Induction/Fuel Injector/Testing and Inspection)Fuel Injector Diagnosis (J39021 or Scan Tool) (See:
Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Testing and Inspection).
No comments:
Post a Comment