2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2037
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0351
- Ignition Coil 1 Control Circuit
DTC P0352
- Ignition Coil 2 Control Circuit
DTC P0353
- Ignition Coil 3 Control Circuit
DTC P0354
- Ignition Coil 4 Control Circuit
DTC P0355
- Ignition Coil 5 Control Circuit
DTC P0356
- Ignition Coil 6 Control Circuit
DTC P0357
- Ignition Coil 7 Control Circuit
DTC P0358
- Ignition Coil 8 Control Circuit
Diagnostic Fault Information
Circuit/System Description
The ignition system on this engine uses an individual coil/module for each cylinder. The engine control module (ECM) controls the spark event for
each cylinder through the eight individual ignition control (IC) circuits. When the ECM commands the IC circuit ON, electrical current will flow
through the primary winding of the ignition coil, creating a magnetic field. When a spark event is requested, the ECM will command the IC circuit
OFF, interrupting current flow through the primary winding. The magnetic field created by the primary winding will collapse across the secondary
coil windings, producing a high voltage across the spark plug electrodes. The ECM uses information from the crankshaft position (CKP) sensor,
and the camshaft position (CMP) sensor for sequencing and timing of the spark events. Each ignition coil/module assembly has the following
circuits:
* Ignition voltage
* Ground
* Ignition control (IC)
* Low reference
If the ECM detects that the IC circuit has an incorrect voltage level, DTC P0351-P0358 will set.
Conditions for Running the DTC
* The ignition is ON.
* DTC P0351-P0358 runs continuously when the above condition is met.
No comments:
Post a Comment