2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1970

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1970

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information.

Circuit/System Verification

1. Start the engine.

2. Let the engine run for 1 minute, then turn the key OFF for 30 seconds.

3. Retest for DTC P279D.

Circuit/System Testing

1. Observe the 4WD Signal in the ECM Data List. The 4WD signal should display Enabled when you shift into 4WD and Disabled when you

shift into 2WD.

瀚慖f the scan tool display does not match the transfer case range switch state, repair the transfer case system refer to Diagnostic Starting

Point - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Starting Point - Vehicle).

瀚慖f the scan tool matches the transfer case range switch state, continue with testing.

2. Program the HPCM with the latest software version and retest for DTCs.

瀚慖f the DTC resets, replace the HPCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning)for HPCM replacement, setup, and programming.

P0300

DTC P0300-P0308

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0300

- Engine Misfire Detected

DTC P0301

- Cylinder 1 Misfire Detected

DTC P0302

- Cylinder 2 Misfire Detected