2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1954
Typical Scan Tool Data
Circuit/System Description
The throttle body assembly contains 2 throttle position (TP) sensors. The TP sensors are mounted to the throttle body assembly and are not
serviceable. The TP sensors provide a signal voltage that changes relative to throttle blade angle. The engine control module (ECM) supplies the TP
sensors with a common 5 V reference circuit, a common low reference circuit, and two independent signal circuits.
The TP sensors have opposite functionality. TP sensor 1 signal voltage decreases and TP sensor 2 signal voltage increases as the accelerator pedal
increases to wide open throttle (WOT).
Conditions for Running the DTC
* DTC P0641 or P0651 is not set.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The ignition is ON or the engine is operating.
* DTC P0120, P0122, P0123, P0220, P0222, P0223, P2135 run continuously when the above conditions are met.
Conditions for Setting the DTC
P0120
TP sensor 1 voltage is less than 0.325 V or greater than 4.75 V for greater than 1 s.
P0122
The ECM detects that the TP sensor 1 voltage is less than 0.325 V for greater than 1 s.
P0123
The ECM detects that the TP sensor 1 voltage is greater than 4.75 V for greater than 1 s.
P0220
The TP sensor 2 voltage is less than 0.25 V or greater than 4.59 V for greater than 1 s.
P0222
The ECM detects that the TP sensor 2 voltage is less than 0.25 V for greater than 1 s.
P0223
The ECM detects that the TP sensor 2 voltage is greater than 4.59 V for greater than 1 s.
No comments:
Post a Comment