2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1953
5. Install a 3 A fused jumper wire between TP sensor 1 signal circuit terminal D and the 5 V reference circuit terminal E. Verify the scan tool
TP sensor 1 voltage parameter is greater than 4.8 V.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the ECM.
6. Test for 4.8-5.2 V between the TP sensor 2 signal circuit terminal F and ground.
瀚慖f less than specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the
ECM.
瀚慖f greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
7. If all circuits test normal, test or replace the throttle body assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Throttle Body Assembly Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal and Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for Engine Control Module replacement,
programming, and setup
P0222
DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0120
- Throttle Position (TP) Sensor 1 Circuit
DTC P0122
- Throttle Position (TP) Sensor 1 Circuit Low Voltage
DTC P0123
- Throttle Position (TP) Sensor 1 Circuit High Voltage
DTC P0220
- Throttle Position (TP) Sensor 2 Circuit
DTC P0222
- Throttle Position (TP) Sensor 2 Circuit Low Voltage
DTC P0223
- Throttle Position (TP) Sensor 2 Circuit High Voltage
DTC P2135
- Throttle Position (TP) Sensor 1-2 Correlation
Diagnostic Fault Information
No comments:
Post a Comment