Monday, November 16, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2133

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2133

P0562

The engine is running.

P0563

Ignition voltage has been greater than 12 V for 1 second this ignition cycle.

Conditions for Setting the DTC

P0562

The TCM detects system voltage is less than 10 V for 5 out of 6 seconds.

P0563

The TCM detects system voltage is greater than 18 V for 5 out of 6 seconds.

Action Taken When the DTC Sets

DTCs P0562 and P0563 are Type C DTCs.

Conditions for Clearing the DTC

DTCs P0562 and P0563 are Type C DTCs.

Diagnostic Aids

* Observe the driver information center messaging that would indicate the electrical system requires service.

* Inspect for the following conditions:

- Loose or damaged battery terminals

- Loose or corroded connections at the transmission

- Loose or corroded connections at the accessory power module

Reference Information

Schematic Reference

* Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

* Hybrid Controls Schematics ()

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

1. Engine running with the hood open, accessories OFF, measure and record the battery voltage. The voltage should be between 12.6-15.0 V.

瀚慖f not within the specified range, refer to DC Power Conversion Test ().

No comments:

Post a Comment