Saturday, November 7, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Page 649

2010 Cadillac CTS Sedan AWD V6-3.6L Page 649



Circuit/System Verification



Replace the suspected inoperative or malfunctioning key. DTC B3935 should not reset and the vehicle should start.



If the replacement key results in the resetting of DTC B3935, replace the TDM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Replacing Keys (North America except Canada) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and



Repair/Replacing Keys (North America except Canada))Replacing Keys (Canada, Europe, and Asia) (See: Application and ID)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for theft deterrent module replacement, setup, and



programming



B3976



DTC B3976



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B3976 46



- Unconfigured Transponder/Vehicle Configuration Not Programmed



Circuit/System Description



When the theft deterrent module (TDM) is in the learn coded key state, the TDM checks the current key to ensure it has been configured as a proper



vehicle key.



Conditions for Running the DTC



* Ignition is in the Accessory or Run position.



* The TDM is in the learn coded key state.



Conditions for Setting the DTC



The TDM has determined the current key is not configured as a proper vehicle key.



Action Taken When the DTC Sets



* The security indicator will be illuminated.



* Vehicle starting will be disabled.



Conditions for Clearing the DTC



* A current DTC will be cleared when the TDM detects a properly configured vehicle key.



* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.



Reference Information



Schematic Reference



Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer



Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Immobilizer Description and Operation (without Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

No comments:

Post a Comment