Saturday, November 7, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Page 657

2010 Cadillac CTS Sedan AWD V6-3.6L Page 657



Circuit/System Description



The electric parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electric parking brake



control module also contains the logic for applying and releasing the parking brake when commanded by the electric parking brake switch. When



the electric parking brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within



operating range before the control module performs the requested operation. The electric parking brake module contains an internal park brake



solenoid actuator, and performs diagnostics on the solenoid actuator circuitry to verify it is functioning properly



Conditions for Running the DTC



Ignition OFF, ACCESSORY, or RUN mode.



Conditions for Setting the DTC



The electric parking brake module detects an internal parking brake solenoid malfunction.



Action Taken When the DTC Sets



* The electric parking brake is disabled, one release allowed.



* A DIC message and/or a warning indicator may be displayed.



Conditions for Clearing the DTC



* The electric parking brake module clears the history DTC when a current DTC is not detected in 40 ignition cycles.



* The condition for the DTC is no longer present.



Reference Information



Schematic Reference



Park Brake System Schematics (See: Brakes and Traction Control/Parking Brake System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Electronic Parking Brake Control Module Description (See: Brakes and Traction Control/Parking Brake System/Parking Brake Control



Module/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



With a scan tool , perform the Parking Brake Actuator DTC Reset procedure. Verify DTC C028F is not set.



If DTC is set, replace the K83 Electric Parking Brake Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for Electric Parking Brake Module replacement, setup,



and programming



C0035



DTC C0035-C0050



Diagnostic Instructions

No comments:

Post a Comment