Friday, November 13, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Page 398

2010 Cadillac CTS Sedan AWD V6-3.6L Page 398



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



B1516



DTC B1516



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B1516 08



- Battery Current Sensor Signal Invalid



DTC B1516 66



- Battery Current Sensor Wrong Mounting Position



Diagnostic Fault Information



Circuit/System Description



The battery current sensor is a 3-wire hall effect current sensor. The body control module (BCM) supplies 5 V and ground to the battery current



sensor. The battery current sensor measures the amount of current flowing to or from the battery, and supplies a pulse width modulation (PWM)



signal to the BCM. The BCM monitors the battery current signal, and sets DTC B1516 08 if the signal is outside the normal range if 4-96 percent



duty cycle. The BCM also monitors the current polarity, and sets DTC B1516 66 if reverse polarity is detected.



Conditions for Running the DTC



B1516 08



The BCM is awake.



B1516 66



* The BCM is awake.



* The engine is OFF.



Conditions for Setting the DTC



B1516 08



The battery current signal is less than 4 percent or greater than 96 percent duty cycle for 2 minutes.



B1516 66



The battery current polarity is positive for 2 minutes.



Action Taken When the DTC Sets



The regulated voltage control (RVC) is disabled.



Conditions for Clearing the DTC



The DTC passes when the battery current returns to the normal range for 15 seconds.

No comments:

Post a Comment