2010 Cadillac CTS Sedan AWD V6-3.6L Page 668

2010 Cadillac CTS Sedan AWD V6-3.6L Page 668

* The condition for the DTC is no longer present.

* Operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test, and the EBCM will turn off the ABS indicator.

* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Diagnostic Aids

* Inspect the back of the wheel bearing on the encoder surface for metal debris that could cause an erratic reading with the sensor. Do not use a

magnet to clean the debris, or damage to the encoder ring may occur.

* If 2 or more wheel speed sensors are inoperative diagnose each wheel speed sensor individually.

If the customer comments that the ABS indicator is ON only during moist environmental conditions: rain, snow, vehicle wash, etc., inspect the

wheel speed sensor wiring for signs of water intrusion. If the DTC is not current, clear all DTCs and simulate the effects of water intrusion by using

the following procedure:

1. Spray the suspected area with a 5 percent saltwater solution. To create a 5 percent saltwater solution, add 2 teaspoons of salt to 8 fl oz of

water (10 g of salt to 200 ml of water).

2. Test drive the vehicle over various road surfaces: bumps, turns, etc., above 40 km/h (25 mph) for at least 30 seconds.

3. Rinse the area thoroughly when completed.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Observe the scan tool Wheel Speed Sensor parameter. The reading should be the same speed on all sensors when driving in a straight line at a

speed greater than 20 km/h (13 mph).

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.

2. Ignition ON, test for less than 1 V between the ignition voltage circuit terminal of the appropriate sensor listed below and ground.

* Left front sensor circuit terminal 29

* Right front sensor circuit terminal 6

* Left rear sensor circuit terminal 5

* Right rear sensor circuit terminal 2

瀚慖f greater than the specified range, test the ignition voltage circuit for a short to voltage.

3. Test for less than 1 V between the signal circuit terminal of the appropriate sensor listed below and ground.

* Left front sensor circuit terminal 28

* Right front sensor circuit terminal 17

* Left rear sensor circuit terminal 4

* Right rear sensor circuit terminal 3

瀚慖f greater than the specified range, test the signal circuit for a short to voltage.

4. Ignition OFF, test for infinite resistance between the ignition voltage circuit terminal of the appropriate sensor circuit listed below and