Thursday, October 22, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 778

2010 Cadillac Truck SRX AWD V6-3.0L Page 778



C0035 0F - C0050 0F



* Ignition ON



* Vehicle speed is greater than 35 km/h (22 mph)



C0035 18 - C0050 18



* Ignition ON



* Vehicle speed is greater than 10 km/h (6 mph)



C0035 5A - C0050 5A



* Ignition ON



* Vehicle speed is greater than 20 km/h (13 mph)



Conditions for Setting the DTC



C0035 06 - C0050 06



A short to voltage, short to ground or open/high resistance on the wheel speed sensor 12 V reference or low reference circuit is detected for 0.14



second.



C0035 0F - C0050 0F



An erratic wheel speed sensor signal is detected for 0.17 second.



C0035 18 - C0050 18



A missing wheel speed sensor signal is detected for 180 seconds.



C0035 5A - C0050 5A



Difference between fastest and slowest wheel speed is greater than 50% for 30 seconds.



Action Taken When the DTC Sets



* The EBCM disables the ABS, traction control, and stability control for the duration of the ignition cycle.



* The ABS indicator turns ON.



* The traction control/stability control-active indicator turns ON.



Conditions for Clearing the DTC



* A current DTC clears when the diagnostic runs and passes.



* The EBCM will turn OFF the indicator in the next ignition cycle.



Diagnostic Aids



* Do not use a magnet to clean the encoder ring.



* If 2 or more wheel speed sensors are inoperative, diagnose each wheel speed sensor individually.



Reference Information



Schematic Reference



Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)

No comments:

Post a Comment