Friday, October 30, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1728

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1728

DTC Descriptors

DTC P0068

- Throttle Body Airflow Performance

DTC P0121

- Throttle Position (TP) Sensor 1 Performance

Circuit/System Description

The engine control module (ECM) uses the following information to calculate an expected airflow rate:

* The throttle position (TP)

* The barometric pressure (BARO)

* The manifold absolute pressure (MAP)

* The intake air temperature (IAT)

* The engine RPM

Conditions for Running the DTC

P0068

* DTCs P0641, P0651, P1516, P2101, P2119, P2176 are not set.

* The engine is running.

* DTC P0068 run continuously when the above conditions are met.

P0121

* DTCs P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0128, P0315, P0335, P0336 are not set.

* The engine speed is more than 450 RPM.

* DTC P0121 run continuously when the above conditions are met.

Conditions for Setting the DTC

P0068

The ECM detects that the throttle position and the indicated engine load do not correspond with the expected load and throttle position for less than

1 second.

P0121

The predicted air flow and the predicted MAP combined are outside a calibrated range for more than 3 seconds.

Action Taken When the DTC Sets

P0068

* DTC P0068 is a Type A DTC.

* The control module commands the throttle actuator control (TAC) system to operate in the Reduced Engine Power mode.

* A message center or an indicator displays Reduced Engine Power.

* Under certain conditions the control module commands the engine OFF.

P0121

DTC P0121 is a Type B DTC.

Conditions for Clearing the MIL/DTC

* DTC P0068 is a Type A DTC.

* DTC P0121 is a Type B DTC.

Reference Information

Schematic Reference

Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

No comments:

Post a Comment