Saturday, October 24, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1577

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1577

* The ignition is in RUN or CRANK.

* Ignition voltage is 8-18V.

Conditions for Setting the DTC

The control module has detected an internal PLD malfunction.

Action Taken When the DTC Sets

* DTCs P1AFB and P1B01 are Type A DTCs.

* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTCs P1AFB and P1B01 are Type A DTCs.

Diagnostic Aids

An intermittent loss of battery voltage to the drive motor generator power inverter module assembly (PIM) may set this DTC.

Reference Information

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Clear the DTC information.

2. Ignition OFF for 1 minute.

3. Ignition ON.

4. Retest for DTC P1AFB or P1B01.

Circuit/System Testing

1. Ignition OFF.

2. Wait 2 minutes.

3. Disconnect PIM connector X1.

4. Ignition OFF.

5. Wait 2 minutes.

6. Reconnect PIM connector X1.

7. Ignition ON, retest for DTC P1AFB or P1B01.

瀚慖f the DTC resets, program the PIM with the latest software version and recheck for DTCs. If the DTC resets after programming or if the

PIM already contains the latest software version, replace the PIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup, and programming.

P1B02

DTC P1AFC, P1AFD, or P1B02

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment