2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1726

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1726

* A battery charger must NOT be connected to the battery when programming a control module.

2. Ignition ON, with a scan tool verify that DTC P0602 is not set.

瀚慖f DTC P0602 is set, program the transmission control module. Refer to Service Programming System (SPS) (See: Testing and

Inspection/Programming and Relearning/Service Programming System (SPS)) and Control Solenoid Valve and Transmission Control

Module Assembly Programming and Setup (2ML70) (See: Powertrain Management/Transmission Control Systems/Relays and Modules

- Transmission and Drivetrain/Relays and Modules - A/T/Control Module/Testing and Inspection/2ML70 - Automatic Transmission

)Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6L45/6L50/6L80/6L90) (See:

Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and Modules -

A/T/Control Module/Testing and Inspection/6L45/6L50/6L80/6L90 - Automatic Transmission).

3. Verify with a scan tool that DTCs P0601, P0603, P0604, or P062F are not set.

瀚慖f DTCs P0601, P0603, P0604, or P062F are set, replace the control solenoid valve and transmission control module assembly.

4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement,

setup, and programming.

P064A

DTC P1255 or P064A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptors

DTC P064A

- Fuel Pump Control Module Performance

DTC P1255

- Fuel Pump Control Module Driver Over-temperature

Circuit/System Description

The engine control module (ECM) supplies voltage to the fuel pump control module when the ECM detects that the ignition is on. The voltage from

the ECM to the fuel pump control module remains active for 2 seconds, unless the engine is in crank or run. While this voltage is being received,

the fuel pump control module supplies a varying voltage to the fuel tank pump module in order to maintain the desired fuel rail pressure.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The fuel pump control module detects an over-temperature fault.

Action Taken When the DTC Sets

DTCs P064A and P1255 are Type A DTCs.

Conditions for Clearing the DTC