2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1741

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1741

* 1-3 Clutch Housing Overhaul (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Overhaul/2ML70 -

Automatic Transmission/36. 1-3 Clutch Housing Overhaul) for 1-3 clutch assembly repair or replacement.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement,

setup, and programming.

P0101

DTC P0101 or P1101

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0101

- Mass Air Flow (MAF) Sensor Performance

DTC P1101

- Intake Air Flow System Performance

Diagnostic Fault Information

Typical Scan Tool Data

Circuit Description

The intake flow rationality diagnostic provides the within-range rationality check for the mass air flow (MAF), manifold absolute pressure (MAP),

and the throttle position (TP) sensors. This is an explicit model-based diagnostic containing 4 separate models for the intake system.

* The throttle model describes the flow through the throttle body and is used to estimate the MAF through the throttle body as a function of

barometric pressure (BARO), TP, intake air temperature (IAT), and estimated MAP. The information from this model is displayed on the

scan tool as the MAF Performance Test parameter.

* The first intake manifold model describes the intake manifold and is used to estimate MAP as a function of the MAF into the manifold from

the throttle body and the MAF out of the manifold caused by engine pumping. The flow into the manifold from the throttle uses the MAF

estimate calculated from the above throttle model. The information from this model is displayed on the scan tool as the MAP Performance

Test 1 parameter.

* The second intake manifold model is identical to the first intake manifold model except that the MAF sensor measurement is used instead of

the throttle model estimate for the throttle air input. The information from this model is displayed on the scan tool as the MAP Performance

Test 2 parameter.

* The fourth model is created from the combination and additional calculations of the throttle model and the first intake manifold model. The

information from this model is displayed on the scan tool as the TP Performance Test parameter.

The estimates of MAF and MAP obtained from this system of models and calculations are then compared to the actual measured values from the

MAF, MAP, and the TP sensors and to each other to determine the appropriate DTC to fail. The following table illustrates the possible failure

combinations and the resulting DTC or DTCs.