Thursday, October 29, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1658

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1658



瀚慖f not the specified value, test the control circuit for an open/high resistance. If the circuit tests normal, replace the ECM.



7. If all the circuits test normal, test or replace the reverse lockout assembly.



Repair Instructions



* Reverse Lockout Solenoid Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids -



Transmission and Drivetrain/Actuators and Solenoids - M/T/Shift Solenoid/Service and Repair/Reverse Lockout Solenoid Replacement)



* Engine Control Module Programming and Setup (w/LF1) (See: Powertrain Management/Computers and Control Systems/Engine Control



Module/Testing and Inspection)Engine Control Module Programming and Setup (w/LLT) (See: Powertrain Management/Computers and



Control Systems/Engine Control Module/Testing and Inspection)Engine Control Module Programming and Setup (V8) (See: Powertrain



Management/Computers and Control Systems/Engine Control Module/Testing and Inspection)



* Engine Control Module Replacement (See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and



Repair)



Repair Verification



1. Install any components or connectors that have been removed or replaced during diagnosis.



2. Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.



3. Clear the DTCs.



4. Turn OFF the ignition for 60 seconds.



5. Engine running, command reverse lockout solenoid ON and OFF with a scan tool, while observing the reverse inhibit circuit status



parameters. The circuit status parameters should change from OK to Not Run or Not Run to OK.



瀚慖f another DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) and perform the appropriate diagnostic procedure.



Aisin AY6 - Manual Transmission



DTC P0806



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0806



- Clutch Pedal Position (CPP) Sensor Circuit Performance



Diagnostic Fault Information



Typical Scan Tool Information

No comments:

Post a Comment