Saturday, August 29, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1708

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1708



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0965



- Clutch Pressure Control (PC) Solenoid 2 System Performance



DTC P0966



- Clutch Pressure Control (PC) Solenoid 2 Control Circuit Low Voltage



DTC P0967



- Clutch Pressure Control (PC) Solenoid 2 Control Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The clutch pressure (PC) solenoid 2 is part of the control solenoid valve assembly which has no serviceable parts. The normally high clutch PC



solenoid 2 regulates and directs the clutch PC solenoid 2 oil pressure to the 3-5 reverse clutch regulator valve and 3-5 reverse clutch boost valve.



Increasing clutch PC solenoid 2 pressure increases pressure to the 3-5 reverse clutch. The TCM varies the current to the PC solenoid 2 through a



low side driver. Decreasing the current to the clutch PC solenoid 2 increases clutch PC solenoid 2 oil pressure by closing OFF the solenoid exhaust



port. Increasing the current to the clutch PC solenoid 2, decreases clutch PC solenoid 2 oil pressure by opening the solenoid exhaust port. Clutch



PC solenoid 2 power is supplied by the TCM through a high side driver (HSD). The HSD protects the circuit and components from excessive



current flow. If excessive current flow is detected, the HSD will turn OFF. When the fault is corrected, the HSD will reset.



Conditions for Running the DTC



P0965, P0966, or P0967



* DTCs P0965, P0966, or P0967 have not set this ignition.



* The ignition voltage is 8.6 volts or greater.



* The engine run time is greater than 5 seconds.



* The clutch PC solenoid 2 is commanded ON.



Conditions for Setting the DTC



P0965



The TCM detects an internal electrical performance malfunction of the clutch PC solenoid 2 control circuit where the measured clutch PC solenoid



2 current does not equal the commanded clutch PC solenoid 2 current for 5 seconds.



P0966



The TCM detects a short to ground on the clutch PC solenoid 2 control circuit for 1 second.

No comments:

Post a Comment