Note!
The conversion described as shown only applies for vehicles in which the bellows first version A (with 2 rubber bellows -1 and 2-) is installed!
Overview of Bellows Conversion
^ To convert the bellows variant -A- to version -A1-, the hydraulic unit, the brake booster -4- with brake master cylinder and the intermediate
piece -11- must be removed.
^ The assembly of the brake master cylinder with the brake booster -4- must not be disconnected for removal and installation if both parts should
be continued to be used!
^ To remove the intermediate piece -11-the battery must be removed! This will prevent damage of the components in the surrounding area.
^ The following parts must be exchanged or replaced for first installation of variant -A1- (replacement):
- Remove short bellows -2- on the brake booster and the long bellows -1- on the firewall.
- Remove the grommet (rubber groove ring) -3- for mounting the long (former) bellows (not replaced).
- The following parts are used in place of the removed parts -1 / 2 / 3-: Bellows -B- (already mounted on new brake boosters), connection
The conversion described as shown only applies for vehicles in which the bellows first version A (with 2 rubber bellows -1 and 2-) is installed!
Overview of Bellows Conversion
^ To convert the bellows variant -A- to version -A1-, the hydraulic unit, the brake booster -4- with brake master cylinder and the intermediate
piece -11- must be removed.
^ The assembly of the brake master cylinder with the brake booster -4- must not be disconnected for removal and installation if both parts should
be continued to be used!
^ To remove the intermediate piece -11-the battery must be removed! This will prevent damage of the components in the surrounding area.
^ The following parts must be exchanged or replaced for first installation of variant -A1- (replacement):
- Remove short bellows -2- on the brake booster and the long bellows -1- on the firewall.
- Remove the grommet (rubber groove ring) -3- for mounting the long (former) bellows (not replaced).
- The following parts are used in place of the removed parts -1 / 2 / 3-: Bellows -B- (already mounted on new brake boosters), connection
Comments
Post a Comment