2. Remove long gearshift lever (standard version).
DANGER
Risk of accidents (eye injuries) while removing the gearshift lever.
^ Wear protective goggles when knocking off the pins at the bushings (plastic).
2.1 Knock off pins --> Figure 6 -A- at the bushings (plastic) with a chisel.
2.2 Remove bushings from the gearshift bracket --> Figure 6 -Arrows-.
2.3 Guide gearshift lever --> Figure 6 -B- upwards out of the gearshift bracket.
3. Check whether a green clip --> Figure 7- Section- is installed on the base of the gearshift bracket.
3.1 If you see a green clip:
Press green clip downwards --> Figure 7 -Arrow A- and unclip it towards the front --> Figure 7- Arrow B- out of the gearshift bracket.
Background:
If the clip remains in the gearshift bracket, the shift cables will rub against the clip.
3.2 If there is no green clip:
Continue with the next step.
4. Install short gearshift lever.
4.1 Lightly lubricate pin and ball pin on the new gearshift lever using approx. 3 g of lubricant.
4.2 Guide gearshift lever into the gearshift bracket --> Figure 8- A-.
4.3 Position new bushing on gearshift bracket in such a way that the two pins stand vertically at the base of the bushing --> Figure 8 -D-
DANGER
Risk of accidents (eye injuries) while removing the gearshift lever.
^ Wear protective goggles when knocking off the pins at the bushings (plastic).
2.1 Knock off pins --> Figure 6 -A- at the bushings (plastic) with a chisel.
2.2 Remove bushings from the gearshift bracket --> Figure 6 -Arrows-.
2.3 Guide gearshift lever --> Figure 6 -B- upwards out of the gearshift bracket.
3. Check whether a green clip --> Figure 7- Section- is installed on the base of the gearshift bracket.
3.1 If you see a green clip:
Press green clip downwards --> Figure 7 -Arrow A- and unclip it towards the front --> Figure 7- Arrow B- out of the gearshift bracket.
Background:
If the clip remains in the gearshift bracket, the shift cables will rub against the clip.
3.2 If there is no green clip:
Continue with the next step.
4. Install short gearshift lever.
4.1 Lightly lubricate pin and ball pin on the new gearshift lever using approx. 3 g of lubricant.
4.2 Guide gearshift lever into the gearshift bracket --> Figure 8- A-.
4.3 Position new bushing on gearshift bracket in such a way that the two pins stand vertically at the base of the bushing --> Figure 8 -D-
Comments
Post a Comment