Monday, July 20, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 683

2010 Cadillac Truck SRX AWD V6-3.0L Page 683



Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System



Diagram/Headlights/Daytime Running Lights (DRL) Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool High Beam Select Switch parameter while pulling and releasing the turn signal/multi-function switch. The value



should change between Inactive and Active when changing between the selected states.



Circuit/System Testing



1. Ignition OFF, disconnect at the S78 turn signal/multifunction switch.



2. Ignition ON, verify that the scan tool High Beam Select Switch parameter is Inactive.



瀚慖f not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K9 BCM.



3. Connect a 3 A fused jumper wire between the signal circuit terminal 2 and ground, verify that the scan tool High Beam Select Switch



parameter is Active.



瀚慖f not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9



BCM.



4. If all circuits test normal, test or replace the S78 turn signal/multifunction switch.



Component Testing



Turn Signal/Multifunction Switch Test



1. Ignition OFF, disconnect the harness connector at the S78 turn signal/multifunction switch.



2. Test for Infinite resistance between the terminals listed below with the switch in the open position.



* Signal terminal 2 and ground terminal 3



* Signal terminal 4 and ground terminal 3



瀚慖f not the specified value, replace the S78 turn signal/multifunction switch.



3. Test for less than 2 ohm between the signal terminal 2 and the ground terminal 3 with the switch in the high beam position.



瀚慖f greater than the specified value, replace the S78 turn signal/multifunction switch.



4. Test for less than 2 ohm between the signal terminal 4 and the ground terminal 3 while holding the switch in the flash to pass position.



瀚慖f greater than the specified value, replace the S78 turn signal/multifunction switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Turn Signal Multifunction Switch Replacement (See: Lighting and Horns/Sensors and Switches - Lighting and Horns/Turn Signal



Switch/Service and Repair/Turn Signal Multifunction Switch Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, programming and setup

No comments:

Post a Comment