2010 Cadillac Truck SRX AWD V6-3.0L Page 161

2010 Cadillac Truck SRX AWD V6-3.0L Page 161

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Replace the S3 Automatic Transmission Shift Lever and verify that the DTC does not reset.

If the DTC resets, replace the K9 Body Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Automatic Transmission Range Selector Lever Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift

Linkage/Service and Repair) for MXE

* Automatic Transmission Range Selector Lever Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter

A/T/Service and Repair/6T70/6T75 - Automatic Transmission/Automatic Transmission Range Selector Lever Replacement) for MH2, MH4

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

B0074

DTC B0074

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B0074 00

- Passenger Presence Sensor Circuit Malfunction

DTC B0074 04

- Passenger Presence Sensor Open

Circuit/System Description

The passenger presence module monitors the sensor status continually. Whenever the sensor mat has an internal malfunction, the passenger

presence module will set DTC B0074.

Conditions for Running the DTC

Ignition voltage is between 9-16 V.

Conditions for Setting the DTC

B0074 00

The passenger presence module has detected a disconnection from the sensor mat.

B0074 04

The passenger presence module has detected an open circuit.