Tuesday, July 21, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1781

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1781



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine running, park brake applied, drive wheels chocked. Shift the transmission into the manual (M) position. Verify with a scan tool the



following TCM parameters display the correct values:



* Drivers Shift Control - Inactive



* Drivers Shift Request - None



2. Verify with a scan tool the following TCM parameters display the correct values when pressing the automatic transmission manual shift



switch-right:



* Drivers Shift Control - Active



* Drivers Shift Request - Upshift



3. Verify with a scan tool the following TCM parameters display the correct values when pressing the automatic transmission manual shift



switch-left:



* Drivers Shift Control - Active



* Drivers Shift Request - Downshift



Circuit/System Testing



1. Ignition OFF, disconnect the automatic transmission manual shift switch left and right wire harness connector.



2. Ignition ON, test for 11-13 volts on terminal 2 on both the automatic transmission manual shift switch left and right harness connectors and



ground.



瀚慖f not within the specified value, test the voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the BCM.



3. Ignition OFF, test for infinite resistance between terminal 1 and terminal 2 on the automatic transmission manual shift switch-right, with the



switch open.



瀚慖f not the specified value, replace the automatic transmission manual shift switch-right



4. Ignition OFF, test for 1.20-1.50 k ohm between terminal 1 and terminal 2 on the automatic transmission manual shift switch-right, with the



switch closed.



瀚慖f not within the specified value, replace the automatic transmission manual shift switch-right.



5. Ignition OFF, test for infinite resistance between terminal 1 and terminal 2 on the automatic transmission manual shift switch-left, with the



switch open.



瀚慖f not within the specified value, replace the automatic transmission manual shift switch-right.



6. Ignition OFF, test for 1.50-1.80 k ohm between terminal 1 and terminal 2 on the automatic transmission manual shift switch-left, with the



switch closed.



瀚慖f not within the specified value, replace the automatic transmission manual shift switch-left.



7. Ignition OFF, connect a 3A fused jumper wire between terminal 1 and terminal 2 on the automatic transmission manual shift switch-left



harness connector.



8. Ignition ON, test for 11-13 volts on the BCM connector X1 terminal 7 and ground.



瀚慖f not within the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the BCM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Refer to Manual Shift Auxiliary Position Switch Replacement - Steering Wheel ().



* Replace the body control module. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for



replacement, setup, and programming.

No comments:

Post a Comment