2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2733

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2733

Diagnostic Aids

When attempting to set solenoid electrical DTCs, ensure the transmission control module is warmed up and the transmission is operated long

enough to ensure a 3掳C (5掳F) increase in TCM temperature parameter. This will place the transmission control module under the optimal conditions

to test solenoid electrical DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

1. Engine ON, verify the transmission fluid temperature is between 50-80掳C (122-176掳F).

2. Operate the vehicle long enough to verify at least a 3掳C (5掳F) rise in TCM temperature parameter, then operate the vehicle in Park for 5

seconds.

3. Engine ON, observe the scan tool Clutch PC 2 Sol. CKT Status parameter. The reading should display OK or Indeterminate.

瀚慖f the reading is not within the specified range, replace the control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming.

6L50/6L80/6L90 - Automatic Transmission

DTC P0965-P0967

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0965

- Clutch Pressure Control (PC) Solenoid 2 System Performance

DTC P0966

- Clutch Pressure Control (PC) Solenoid 2 Control Circuit Low Voltage