Affected functions:
- Transmission mode selection
- Drive position selection
-------------------------------------------------
Test 1: Remedial action in the event of implausible signals from control unit N73 (EIS [EZS] control unit)
1. Remedial action in the event of implausible signals from control unit N73 (EIS [EZS] control unit)
Operation number of operation texts and work units or standard texts and flat rates:27-0641WARNING
- This is not a function error of control module N15/3 (ETC [EGS] control unit) and does not justify replacement.
Possible cause for the entry of this event code
- Operational fault of component N73 (EIS [EZS] control unit)
Possible measures
- Read out fault memory of control unit N73 (EIS [EZS] control unit).
- Process displayed fault codes in control module N73 (EIS [EZS] control unit).
End of test
EU044700
Implausible data were received from the central gateway.
Possible cause:
- N93 (Central gateway control unit)
Affected functions:
- Transmission mode selection
- Drive position selection
-------------------------------------------------
Test 1: Remedial action in the event of implausible signals from control unit N93 (Central gateway control unit)
1. Remedial action in the event of implausible signals from control unit N93 (Central gateway control unit)
Operation number of operation texts and work units or standard texts and flat rates:27-0641WARNING
- This is not a function error of control module N15/3 (ETC [EGS] control unit) and does not justify replacement.
Possible cause for the entry of this event code
- Operational fault of component N93 (Central gateway control unit)
Possible measures
- Read out fault memory of control unit N93 (Central gateway control unit).
- Process displayed fault codes in control module N93 (Central gateway control unit).
End of test
EU113C00
The wheel speed signals were not received.
Possible cause:
- Check the CAN communication with control unit N30/4 (Electronic Stability Program control unit).
- Chassis CAN bus
Affected functions:
- Transmission mode selection
- Drive position selection
-------------------------------------------------
Test 1: Check the CAN communication with control unit N30/4 (Electronic Stability Program control unit).
No comments:
Post a Comment