Monday, February 24, 2020

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 1313


1.5. Test voltage supply of the potentiometers of component M16/6 (Throttle valve actuator).



Test prerequisite



- At least one of the relevant actual values is not okay.



- The power supply of component N3/10 (ME-SFI [ME] control unit) is OK.



Test sequence



- Switch off ignition.



- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).



- Measure direct voltage with multimeter between sockets (M.39) 39 and (M.43) 43 of the 35-pole socket box tester.



- Switch on ignition.



Specified value



- Voltage[4.75...5.25] V



Question



- Is the measurement value OK?



YES



The measurement value is OK.Possible cause and remedy



- Check lines from component M16/6 (Throttle valve actuator) to component N3/10 (ME-SFI [ME] control unit).



End of test



NO



The measurement value is not OK.Possible cause and remedy



- N3/10 (ME-SFI [ME] control unit)



End of test



2. Check air filter and intake tract for blockage.



Possible cause of fault



- Intake system clogged



Possible remedy



- Check entire air intake system for unmetered air.



End of test



2167



This fault can be ignored and erased.



Possible cause:



- This fault can be ignored and erased.



Affected functions:



- Engine diagnosis



-------------------------------------------------



Test 1: This fault can be ignored and erased.



1. This fault can be ignored and erased.



Note:This fault can be ignored and erased.



2168



This fault can be ignored and erased.



Possible cause:



- This fault can be ignored and erased.

No comments:

Post a Comment