2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1656

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1656

DTC P0816

- Downshift Switch Circuit

DTC P0826

- Up and Down Shift Switch Circuit

Diagnostic Fault Information

Circuit/System Description

When the shift lever is placed in manual mode (M) this activates the driver shift request (DSR), also known as the tap shift function. The DSR

allows the vehicle operator to shift gears by pressing the plus (+) button for an upshift or the minus (-) button for a downshift. A 12 volt signal

circuit is provided by the body control module (BCM) to the plus or minus buttons. When a plus or minus button is pressed, a corresponding

voltage drop occurs across the resistor network embedded in the switches. This voltage drop is monitored by the transmission control module

(TCM). The TCM will command the upshift or downshift providing the operating conditions are correct.

Conditions for Running the DTC

P0815 or P0816

* No DTCs P0815, P0816, P0826, P1761, P182E, P1876, P1877, or P1915.

* The time since the range change is greater than 1 second.

* The engine speed is 400 RPM or greater for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

P0826

* The engine speed is greater than 400 RPM for at least 5 seconds.

* The ignition voltage is 8.6 volts or greater.

* No DTC 1761.

Conditions for Setting the DTC

P0815 - Condition 1

The TCM detects an upshift request for 1 second in PARK or neutral.

P0815 - Condition 2

The TCM detects an upshift request for 10 minutes in any forward range.

P0816 - Condition 1

* The TCM detects a downshift request for 1 second in PARK or neutral.

* The TCM detects a downshift request for 10 minutes in any forward range.

P0826

The TCM detects an invalid voltage on the TAP up/down signal circuit for 1 minute.

Action Taken When the DTC Sets

* DTCs P0815, P0816, and P0826 are Type C DTCs.

* The TCM disables TAP shift operation.

Conditions for Clearing the DTC

DTCs P0815, P0816, and P0826 are Type C DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference