Saturday, February 22, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1695

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1695



DTC P0748 or P0961-P0963



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0748



- Line Pressure Control Solenoid Valve System Performance



DTC P0961



- Line Pressure Control Solenoid Valve System Performance



DTC P0962



- Line Pressure Control Solenoid Valve Control Circuit Low Voltage



DTC P0963



- Line Pressure Control Solenoid Valve Control Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



Line pressure control solenoid (SLT) is part of the front valve body. SLT regulates the transmission fluid line pressure in accordance with the value



decided in the transmission control module (TCM) based on throttle opening signal and engine torque. Through this, it controls operating hydraulic



pressure to the clutch and brakes for smooth shifting. The TCM varies the current to the normally SLT from 0.1 A for maximum line pressure, to



1.1 A for minimum line pressure. As a fail-safe function, if SLT abnormality occurs, the TCM will disable the current. In that case the line pressure



is maximized.



Conditions for Running the DTC



P0748



* The ignition voltage is 10.2-15.5 V.



* The engine speed is greater than 400 RPM for 2 s.



* The transmission is not in emergency mode.



* Driving in D range.



* TCM communication is normal.



* DTCs P0962 and P0963 are not set.



P0961



* The ignition voltage is 10.2-15.5 V.



* The engine speed is greater than 400 RPM for 2 s.



* The transmission is not in emergency mode.



* Driving in D range.



* TCM communication is normal.



* The Automatic Transmission Fluid Temperature is more than 20掳C (68掳F)

No comments:

Post a Comment