2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2688

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2688

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

Ignition ON, observe the scan tool Driver Shift Request parameter while toggling between the up shift and down shift with the driver manual shift

switches. The reading should change between Upshift and Downshift.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S2 transmission manual shift switch.

2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 4 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Verify the scan tool Driver Shift Request parameter is Invalid.

瀚慖f not the specified value, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the K9 body control

module.

4. Install a 6.5-7.0K ohm jumper wire between the signal circuit terminal 3 and the B+ circuit terminal 4. Verify the scan tool Driver Shift

Request parameter is None.

瀚慖f not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the K9 body control

module.

5. If all circuits test normal, test or replace the S2 transmission manual shift switch.

Component Testing

1. Ignition OFF, disconnect the harness connector at the S2 transmission manual shift switch.

2. Test for 6.5-7.0K ohm between the signal terminal 3 and the B+ terminal 4 with the switch in the released position.

瀚慖f not the specified value, replace the S2 transmission manual shift switch.

3. Test for 1.5-2.0K ohm between the signal terminal 3 and the B+ terminal 4 with the switch in the plus position.

瀚慖f greater than the specified range, replace the S2 transmission manual shift switch.

4. Test for 3.8-4.0K ohm between the signal terminal 3 and the B+ terminal 4 with the switch in the minus position.

瀚慖f greater than the specified range, replace the S2 transmission manual shift switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Shift Lever Replacement (See: Steering and Suspension/Steering/Steering Column/Service and Repair/Shift Lever Replacement) for

automatic transmission manual shift switch replacement.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for body control module replacement, setup, and

programming.

P0842

DTC P0842 or P0843

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure