2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2629
DTC P0722
- Output Speed Sensor Circuit Low Voltage
DTC P0723
- Output Speed Sensor Circuit Intermittent
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The Automatic Transmission Output Shaft Speed Sensor assembly has 2 internal hall-effect type sensors, and is capable of sensing both speed and
direction. The Automatic Transmission Output Shaft Speed Sensor mounts to the A/T rear case assembly and is connected to the control solenoid
valve assembly through a wire harness and connector. The sensor faces the hybrid direct, 2-3-4 clutch housing assembly machined teeth surface.
The sensor receives 8.3-9.3 volts on the OSS supply voltage circuit from the transmission control module. As the output shaft rotates, the sensor
produces a signal frequency based on the machined surface of the output shaft.
The two sensor elements in the Automatic Transmission Output Shaft Speed Sensor assembly are spaced approximately 1/2 a tooth apart.
* When the vehicle is moving in a forward direction, sensor A detects a particular tooth before sensor B.
* When the vehicle is moving in a reverse direction, sensor B detects a particular tooth before sensor A.
The electronics in the sensor combine the two signals and send a signal with a different pulse width. This signal is interpreted by the TCM for speed
and direction and is transmitted through the data communication circuits to the engine control module (ECM) and the hybrid powertrain control
module. The ECM, hybrid powertrain control module, and transmission control module compare the OSS signal with the ABS wheel speed sensor
signal.
Conditions for Running the DTC
P0721
The ignition is ON.
P0722
* No OSS DTCs P0721 or P0723.
* The selected range is not PARK or NEUTRAL.
* The vehicle speed is greater than 16 km/h (10 mph).
P0723
* No Automatic Transmission Output Shaft Speed Sensor DTCs P0721 or P0722.
* The engine run time is greater than 6 seconds.
Conditions for Setting the DTC
P0721
The transmission control module detects an invalid Automatic Transmission Output Shaft Speed Sensor direction.
P0722
* The transmission control module detects no signal from the Automatic Transmission Output Shaft Speed Sensor.
* The transmission output speed is less than 50 RPM for 1.5 seconds.
P0723
* The transmission control module detects an unrealistic signal drop from the Automatic Transmission Output Shaft Speed Sensor.
* Automatic Transmission Output Shaft Speed Sensor DTC P0723 has not failed this ignition.
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Wednesday, February 26, 2020
2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2629
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment