2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1452
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0601
- Transmission Control Module (TCM) Read Only Memory (ROM)
DTC P0602
- Transmission Control Module (TCM) Not Programmed
DTC P0603
- Transmission Control Module (TCM) Long Term Memory Reset
DTC P0604
- Transmission Control Module (TCM) Random Access Memory (RAM)
DTC P062F
- Transmission Control Module (TCM) Long Term Memory Performance
Circuit/System Description
This is an internal fault detection of the control solenoid (w/body and TCM) valve assembly. This fault is handled inside the control solenoid
(w/body and TCM) valve assembly and no external circuits are involved.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The control solenoid (w/body and TCM) valve assembly has detected an internal malfunction.
Action Taken When the DTC Sets
* DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.
* The TCM shifts to a default gear, shuts down, and turns OFF.
Conditions for Clearing the DTC
DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.
Reference Information
Description and Operation
Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -
Automatic Transmission/Electronic Component Description) for control solenoid (w/body and TCM) valve assembly
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Engine running for at least 1 minute.
2. Ignition OFF for 30 seconds.
3. Ignition ON, verify that DTC P0602 is not set.
瀚慖f the DTC is set, program the transmission control module (TCM). If the DTC resets, replace the control solenoid (w/body and TCM)
No comments:
Post a Comment