Thursday, January 9, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 2020



With a scan tool, attempt to communicate with all modules.



Circuit/System Testing



1. With a scan tool, verify DTC U0100-U0299 or U2105-U2199 is not set as current.



瀚慖f DTC is set, refer to DTC U0100-U02FF (See: U Code Charts/U0100) or DTC U2105-U2199 (See: U Code Charts/U2105).



2. Ignition OFF, test for less than 5 ohm between the applicable module ground circuit and ground.



瀚慖f greater than the specified range, test the circuit for an open/high resistance.



3. Ignition OFF, disconnect the applicable module harness connector.



4. Ignition ON, verify a test lamp illuminates between the following circuits of the applicable module and ground:



* The battery positive voltage input circuits



* The battery positive voltage output circuits



* The ignition voltage input circuits



* The ignition voltage output circuits



* The switched battery positive voltage supply circuits



瀚慖f the test lamp does not illuminate, test the circuit for an open/high resistance. If the circuit fuse is open, test the circuit for a short to



ground. If the circuit tests normal, replace the applicable control module.



5. Ignition OFF, test for less than 5 ohm between the non-communicating modules GMLAN serial data circuits and the module reporting DTC



U0002.



瀚慖f greater than the specified range, test the circuit for an open/high resistance.



6. If all circuits test normal, replace the applicable control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming



* GMLAN Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Wiring Repairs/GMLAN Wiring Repairs)



U02FF



DTC U0100-U02FF



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



Refer to Control Module U Code List (See: Diagnostic Trouble Code Descriptions/Control Module U Code List).



Diagnostic Fault Information

No comments:

Post a Comment