2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1589
DTC Descriptors
DTC P0722
- Output Speed Sensor (OSS) Circuit Low Voltage
DTC P0723
- Output Speed Sensor (OSS) Intermittent
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The output speed sensor (OSS) is a hall-effect type sensor. The sensor faces the front differential transfer drive gear. The sensor receives 8.3-9.3
volts on the OSS supply voltage circuit from the transmission control module (TCM). As the output shaft rotates, the sensor produces a signal
frequency based on the machined surface of the output shaft. This signal is transmitted through the OSS signal circuit to the TCM. The TCM uses
the OSS signal to determine line pressure, transmission shift patterns, torque converter clutch (TCC) slip speed and gear ratio.
Conditions for Running the DTC
P0722
* No DTCs P0101, P0102, P0103, P0121, P0122, P0123, P0716, P0717, or P0723.
* The selected range is not PARK or NEUTRAL.
* The transmission input speed is between 1,000-6,500 RPM.
* The engine speed is between 3,200-5,000 RPM.
* The calc. throttle position is greater than 5 percent.
* The throttle position signal is valid.
* The engine torque is greater than 35 Nm (26 lb ft).
* The engine torque signal is valid.
* The TFT is greater than -40掳C (-40掳F).
* The engine speed is greater than 400 RPM for 5 seconds.
* The ignition voltage is 8.6 volts or greater.
P0723
* No DTCs P0101, P0102, P0103, P0121, P0122, P0123, P0723, P0973, P0974, P0976, P0977.
* Greater than 5 seconds since last range change.
* The engine speed is greater than 400 RPM for 5 seconds.
* The ignition voltage is greater than 8.6 volts.
Conditions for Setting the DTC
P0722
The transmission output speed is 70 RPM or less for 4.5 seconds.
No comments:
Post a Comment