2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1806

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1806

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Engine Control Module replacement, setup, and

programming

P2094

DTC P0010, P0013, P0020, P0023, P2088, P2089, P2090, P2091, P2092, P2093, P2094, or P2095 (Without LF1, LFW)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0010

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Bank 1

DTC P0013

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Bank 1

DTC P0020

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Bank 2

DTC P0023

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Bank 2

DTC P2088

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Bank 1

DTC P2089

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Bank 1

DTC P2090

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Bank 1

DTC P2091

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Bank 1

DTC P2092

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Bank 2

DTC P2093

- Intake Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Bank 2

DTC P2094

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Bank 2

DTC P2095

- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Bank 2

Circuit/System Description

The camshaft position actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is

operating. The Camshaft Position Actuator Solenoid Valve signal from the ECM is pulse width modulated (PWM). The ECM controls the

Camshaft Position Actuator Solenoid Valve duty cycle by controlling the amount of solenoid valve ON time. The Camshaft Position Actuator

Solenoid Valve controls the advance or the retard of each camshaft. The Camshaft Position Actuator Solenoid Valve controls the oil flow that

applies the pressure to advance or retard the camshafts.

Ignition voltage is supplied directly to the Camshaft Position Actuator Solenoid Valve. The ECM controls the solenoid valve by grounding the

control circuit with a solid state device called a driver. The driver is equipped with a feedback circuit that is pulled-up to a voltage. The ECM can

determine if the control circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.

Conditions for Running the DTC

* The engine speed is greater than 80 RPM.

* The ignition voltage is between 10-18 V.