Thursday, January 9, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1813

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1813



P0638



* The ignition is ON or the engine is operating.



* The ignition voltage is greater than 8 V.



* The engine speed is greater than 400 rpm.



* The engine coolant temperature (ECT) is greater than 5掳C (41掳F).



* The intake air temperature (IAT) is 5掳C (41掳F).



* Throttle position adaptation is not active.



* DTCs P0638 run continuously once the above conditions are met for greater than 5 s.



P2100-P2103



* The ignition voltage is greater than 8 V.



* The ignition is ON or the engine is operating.



* DTC P2100-P2103 runs continuously once the above conditions are met.



P2119



* DTC P0111, P0112, P0113, P0116, P0117, P0118, P0119, P0700, P2122, P2123, P2127, P2128, or P2138 is not set.



* The vehicle speed is 0 km/h (0 mph).



* The engine speed is less than 250 RPM.



* The engine coolant temperature (ECT) is 5-85掳C (41-185掳F).



* The intake air temperature (IAT) is 5-60掳C (41-140掳F).



* The ignition voltage is greater than 8 V.



* The accelerator pedal position (APP) is less than 15 percent.



* DTC P2119 runs once per ignition cycle when the above conditions are met for less than 1 s.



Conditions for Setting the DTC



P0638



* The ECM detects that the commanded duty cycle for the range test high is greater than 80 percent for greater than 1 s.



OR



* The ECM detects that the commanded duty cycle for the range test low is greater than 80 percent for greater than 5 s.



P2100



The ECM detects the output circuit for the TAC motor is open, shorted to ground, or shorted to a voltage. The condition exists fro greater than 1 s.



P2101



The ECM detects a 4-50 percent difference between the commanded and the actual throttle plate position, dependant upon the rate of commanded



throttle movement. The condition exists for 1 s.



P2102



The ECM detects an overheat condition with the output driver. The condition exists for 1 s.



P2103



The ECM detects an over load condition with the output driver. The condition exists for 1 s.



P2119



The ECM determines that the throttle valve did not return to the rest position within 1 s. The condition exists for greater than 1 s, or a cumulative of



10 s.



Action Taken When the DTC Sets



DTCs P0638, P2100, P2101, P2102, P2103, and P2119 are Type A DTCs.



Conditions for Clearing the DTC



DTCs P0638, P2100, P2101, P2102, P2103, and P2119 are Type A DTCs.



Diagnostic Aids



Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing the



throttle valve not to close.

No comments:

Post a Comment