2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 785
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the EBCM.
7. Verify the scan tool BMC Primary Piston Position Sensor B parameter is less than 1 V.
瀚慖f greater than the specified range, test the signal circuit terminal 1 for a short to voltage. If the circuit tests normal, replace the EBCM.
8. Install a 3A fused jumper wire between the signal circuit terminal 1 and the 5 V reference circuit terminal 2. Verify the scan tool BMC
Primary Piston Position Sensor B parameter is greater than 4.5 V.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the EBCM.
9. If all circuits test normal, replace the brake master cylinder piston position sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Brake Master Cylinder Primary Piston Position Sensor Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Braking Sensor/Switch/Service and Repair)
* Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic
Control Assembly - Antilock Brakes/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming
C12B2
DTC C012A, C128B, C128E, or C12B2-C12B4
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C012A 00
- Master Cylinder Pressure Sensor
DTC C128E
- Master Cylinder Pressure Sensor
DTC C012A 01
- Master Cylinder Pressure Sensor Short to Battery
DTC C12B3
- Master Cylinder Pressure Sensor Short to Battery
DTC C012A 06
- Master Cylinder Pressure Sensor Short to Ground or Open
DTC C12B2
- Master Cylinder Pressure Sensor Short to Ground or Open
DTC C012A 11
- Master Cylinder Pressure Sensor Above Maximum Threshold
DTC C128B
- Master Cylinder Pressure Sensor Above Maximum Threshold
DTC C012A 0F
- Master Cylinder Pressure Sensor Erratic
DTC C12B4
- Master Cylinder Pressure Sensor Erratic
No comments:
Post a Comment