2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 781
Conditions for Running the DTC
* Ignition ON.
* The ignition voltage is greater than 10 V.
Conditions for Setting the DTC
C012D 00, C128D, C012D 11 or C128A
Internal sensor failure is detected.
C012D 01 or C12BD
A short to battery is detected on the sensor signal circuit.
C012D 06 or C12BC
A short to ground or open is detected signal circuit.
C012D 5A or C120A
The boost pressure being commanded is not being achieved.
C012D OF or C12BE
Signal is erratic and changes faster than physically allowed.
Action Taken When the DTC Sets
* The EBCM disables the ABS and vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Perform Brake Pedal Travel Measurement and Inspection (Non-Hybrid) (See: Brakes and Traction Control/Hydraulic System/Testing and
Inspection/Component Tests and General Diagnostics/Brake Pedal Travel Measurement and Inspection (Non-Hybrid))Brake Pedal Travel
Measurement and Inspection (Two-mode Hybrid) (See: Brakes and Traction Control/Hydraulic System/Testing and Inspection/Component Tests
and General Diagnostics/Brake Pedal Travel Measurement and Inspection (Two-Mode Hybrid))
No comments:
Post a Comment