2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 658

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 658

Conditions for Setting the DTC

The MSM detects a tilt switch input for more than 30 consecutive seconds after the tilt motor movement has stopped.

Action Taken When the DTC Sets

* The tilt motor will be deactivated.

* Memory recall functions will be disabled.

Conditions for Clearing the DTC

* A current DTC will clear when the failed switch input is no longer active.

* A history DTC will clear after 100 ignition cycles.

Diagnostic Aids

An intermittently stuck tilt switch may cause a DTC to set.

Reference Information

Schematic Reference

Steering Wheel Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Steering Wheel Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information

Circuit/System Verification

Ignition ON,observe the scan tool Tilt Up Switch parameter and Tilt Down Switch parameter while cycling the switch between states.The reading

should be Inactive and change to Active when pushing the appropriate switch.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the tilt switch.

2. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal B and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Verify the scan tool tilt switch parameter is Inactive.

瀚慖f not the specified value, test the control circuit listed below for a short to voltage. If the circuit tests normal, replace the MSM.

* Tilt Up Switch terminal C

* Tilt Down Switch terminal A

4. Install a 3A fused jumper wire between the control circuits listed below and the B+ circuit terminal. Verify the scan tool tilt switch parameter

is Active.

* Tilt Up Switch terminal C

* Tilt Down Switch terminal A

瀚慖f not the specified value, test the appropriate control circuit for a short to ground or an open/high resistance. If the circuit tests normal,