Wednesday, December 4, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 664

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 664

Conditions for Setting the DTC

The soft stops have not been learned.

Action Taken When the DTC Sets

* The tilt motor will be deactivated.

* Memory recall functions will be disabled.

Conditions for Clearing the DTC

* A current DTC will clear when the soft stops have been learned.

* A history DTC will clear after 100 ignition cycles.

Reference Information

Schematic Reference

Steering Wheel Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Steering Wheel Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information

Circuit/System Verification

1. Ignition ON, perform the scan tool Learn Column Soft Stops procedure. Refer to Power Tilt Steering Column Calibration (See: Steering and

Suspension/Steering/Steering Column/Testing and Inspection/Programming and Relearning).

2. Operate the vehicle within the Conditions for Running and Setting. Verify DTC B2890 does not reset.

瀚慖f the DTC resets, replace the MSM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming

B3006

DTC B3006

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment